Laptop Security Solutions

STEP 1 - 2

- First of all, ensure that you have the right size of Compucage for your computer.

STEP 2 - Then ensure that you have all the parts identified in the picture to the left. Your Compucage comes with a set of 3 keys. Keep these in a safe place, away from the computer.

Step 3

Installation Option A - Select a suitable and convenient location for your computer and place the two pieces of the base plate where you want the computer to be locked to the floor or work surface

 

Step 3 con't.

Adjust both parts of the stand to accommodate the computer snugly, remove the computer and mark the "hole positions" on the floor or work surface.

Drill four holes in the floor or work surface and bolt the stand in place. One hole should be located at the front and back of each stand.

Step 4

- Slide the adjusting bar into the top housing as shown. Rotate one of the now connected locating bars to fix them in a uniform upright position. You can also adjust the distance between the locking bar and locating bar to fit securely around the sides of the tower by this same maneuver.

Step 5

- Place the computer on the stand and slide the bars together over the computer into both the lock assembly and opposite side retaining hole.

Step 6

- Place the computer on the stand and slide the bars together over the computer into both the lock assembly and opposite side retaining hole.

Installation Option B

(Installation Option B)
Note: As an alternative, you can bolt the cage bar (on the side away from the lock) to a vertical section of a wall, desk or table. Bolt unit down to a sub surface first.